View Single Post
Old 04-25-2006, 10:52 AM   #1
allycat's Avatar
allycat
Registered Users
seller
 
Join Date: Apr 2006
Location: MI
Posts: 1,122
My Mood:
PUL and applique.. in the middle of a project..

Ok, so I remember on the old board that this was discussed a lot. Someone said that you can applique on pul an then iron on another piece of pul over the back to help seal holes. I ironed it on and it stuck together, BUT it is still loose in some areas. Not sure if it will hold up. Do I need to sew it on too? But then that will make more holes. Does it seal more in the dryer when I'm done? Thanks!
__________________
HS mom to 4 kiddos- dd-12, dd-9, dd-6 (autism spectrum) and ds-4
allycat is offline   Reply With Quote